Description
Weekend fishing trips are the best part of the week. Its when we are just ready to ride our boats, cast our fishing lines, and wait for the catch. Relaxing and thrilling at the same time. However, for some of us, it is not always smooth sailing. Without the proper tilt and trim, one could lose a prop, waste fuel, and even get back pain because of a bumpy ride. If you think you are one of those people, then CMC PT-35 Tilt and Trim is the product for you.
This electric Tilt N Trim offers you easy motor angle adjustment for best performance in any load and water condition. The results? A stable ride, top-end speed, greater prop clearance, and fuel efficiency.
Thats not all. Made of 1/4" 6061 T6 extruded aluminum, along with stainless steel fastener, this Tilt N Trim is not only efficient but also durable so you can enjoy a smooth ride for many weekend fishing trips to come.
Key Features:
- For Motors Up to 35 Horsepower and Smaller Motors
- 5 ½ Setback for Enhanced Stability and Performance
- Up to 84° of Tilt and Trim
- 1/4" 6061 T6 Extruded Aluminum Build
- Stainless Steel Fasteners
- Electric Hydraulic Actuator Capable of 7853 lbs of Thrust
- Compatible with Clamp-on or Bolt-on Motors, No Adapter Needed
Note: Before ordering, make sure that the maximum width of the clamp mounting feet or mounting bolts of the motor does not exceed the 11-inch limit of the PT-35 motor mounting area. Mounting bolts are excluded from the package.
The PT-35 is rated for 35 hp and smaller motors. Five and one half inch set-back to enhance stability and performance. 84° of travel. Constructed of 1/4" 6061 T6 extruded aluminum construction with stainless steel fasteners. Electric hydraulic actuator rated at 7853 lbs of thrust. Accommodates clamp-on or bolt-on motors without the need of an adapter. Weighs only 24 pounds. Note: The inside dimension of the motor mounting area of the PT-35 is 11 inches. Before ordering, please make sure that the maximum width of the clamp mounting feet and/or mounting bolts of the motor that must fit into this area does not exceed this 11 inch limit. Refer to the transom view drawings. Mounting bolts are not included with the PT-35. With the touch of a switch you can raise your motor to prevent costly prop damage. Plus, no more back strain! The electric Tilt N Trim allows you to change the angle of your motor to obtain the best performance for your load and water condition to receive a more stable ride, increased top end speed, and get more prop clearance resulting in better fuel efficiency.
